Allied Telesis AlliedView-EMS 4.0.2 QoS-Manager - Manual (Page 119)

AlliedView™-EMS 4.0.2 QoS Manager User’s Guide Page 119 of 146
Property
Name
Description Valid Values
traffic class maximum bandwidth
when the default traffic class
minimum bandwidth is none.
•
0-16777216 bytes
•
0~16384 KB (decimal point
supported)
•
0~16 MB (decimal point
supported)
•
0~0.015628 GB (decimal point
supported)
Note - Byte measures can have the value
b,k,kb,m,mb,g,gb (case insensitive)
Default Traffic
Class
Premarking
Specifies the QoS action to take
on the default traffic class before
bandwidth metering is applied.
•
USEMARKVALUE
•
USEDSCP
•
none
Default Traffic
Class
Remarking
Specifies the action to take after
the metering stage.
•
USEDSCPMAP
•
BWCLASS
•
none
Default Traffic
Class Storm
Status
Determines whether or not
storm protection is enabled for
the default traffic class.
•
enabled
•
disabled
Default Traffic
Class Storm
Window
Specifies time between the polling
of traffic class counters that
checks whether storm protection
should be activated.
This value can be set by entering a
number from 100-60000.
This can also be set to "none".
Default Traffic
Class Storm
Rate
Storm protection is activated
when this rate of traffic is
exceeded. Required when storm
protection is enabled.
This value can be set by entering a value
from 1Kbps up to 10Gbps.
The value may contain decimal fractions
up to 3 decimal places.
This can also be set to "none".
Default Traffic
Class Storm
Action
Specifies the action QoS takes
when a storm is detected on a
port.
•
PORTDISABLE
•
LINKDOWN
•
VLANDISABLE
Default Traffic
Class Storm
Timeout
Specifies the length of time the
port remains disabled after a
storm is detected.
This value can be set by entering a
number from 1-86400.
This can also be set to "none".
Mark Value This parameter specifies an
explicit value to use as an index
into the DSCPMAP table when
the dtcpremarking parameter is
usemarkvalue.
Range: none, 0-63
Port Specifies the port where This can be set by selecting any one of