Allied Telesis AlliedView-EMS 4.0.2 QoS-Manager - Manual (Page 80)

AlliedView™-EMS 4.0.2 QoS Manager User’s Guide Page 80 of 146
6.6.7 Quick Setup
Property Name Description Valid Values
Source UDP Port Specifies the UDP source port of an
UDP/IP packet.
Range: 0-65535 or a port range (n-
m).
Default for VOICE: 1719
Default for VIDEO: 1024
Priority Specifies the priority that will be
assigned for this setup. Range: 0-7
Default for VOICE: 7
Default for VIDEO: 4
Maximum
Bandwidth
Specifies the maximum bandwidth
available to this setup.
•
0-16000000 kbps
•
0-16000 Mbps (decimal point
supported)
•
0-16 Gbps (decimal point
supported)
Default for VOICE: 128kbps
Default for VIDEO: 256kbps
Port Assignment Specifies a list of ports that will be
affected by this setup.
Select from a list of available Ports.
Default for VOICE: no ports
Default for VIDEO: no ports
6.6.8 Notes
•
Configuring the Port and VLAN properties of a Flow Group, Traffic Class or Policy
will have no effect unless the Action or Default Traffic Class Action property is set
to 'SENDVLANPORT'.
•
Values entered for the Maximum Bandwidth traffic class property are rounded up to
the nearest multiple of 648.
•
When the Protocol property is configured, the Ethernet Format property should
also be configured.
•
To configure the Storm Status property, the switch must be in enhanced mode.
•
When the Storm Status property is configured, the Storm Window and Storm Rate
properties should also be configured.
•
Values entered for the Storm Window property are automatically rounded off to
the nearest hundreds.
•
When the IP Protocol classifier property is configured to '0', the current firmware
version automatically converts this value to 'NONTCPUDP'.
•
Valid values for the VLAN Priority classifier property are 'any' and values in the
range [0-7] inclusive. However, when VLAN Priority is set to 'any', the current
firmware version automatically converts the 'any' value to '4294967295'. When this