Nikon SB-910 - Manual (Page 81)

D–20
D
Wireless Multiple Flash-unit Photography
Checking Status in Wireless Multiple Flash-unit Photography
The fl ash-ready indicator on the SB-910 and the sound monitor can be used to
check that wireless multiple fl ash-unit photography is operating during and after
taking a picture.
The sound monitor can be used to check the operational status of a remote flash •
unit. This function can be activated or canceled with function button 3.
When the SB-910 is used in remote mode, either of the flash-ready indicators can
•
be turned off in the custom settings to reduce power consumption. In default
setting, the back flash-ready indicator lights up and the front flash-ready indicator
blinks. (0B-19)
Checking flash operation using the flash-ready indicator or sound
monitor
Master fl ash
unit
Remote fl ash unit
Speedlight status
Flash-ready
indicator
Flash-ready
indicator
Sound
monitor
Lights up
The back
indicator lights
up and the
front indicator
blinks.
One beep Ready to fi re
Goes out and
lights up when
ready to fi re
The back
indicator lights
up and the
front indicator
blinks or goes
out.
Two short
beeps
Fired properly
Blinks for
approx. 3 sec.
Quickly blinks
for approx.
3 sec. Three long
beeps for
approx. 3 sec.
Insuffi cient fl ash output for correct
exposure
*1
Underexposure due to insuffi cient
fl ash output may have occurred.
To compensate, use a wider
aperture or higher ISO sensitivity,
or move the fl ash unit closer to the
subject and reshoot.