Tuner, Ipod/iphone usb device – Sony STR-DN1040 User Manual

Page 119

Advertising
background image

119

US

Addi

tiona

l I

n

fo

rm

a

tio

n

There is a time gap between the audio
output and visual display.

• Check that the PARTY STREAMING

function is not being used. To close a
PARTY, press PARTY CLOSE until
“CLOSE PARTY” appears. For
details, see page 73.

The FM reception is poor.

• Use a 75-ohm coaxial cable (not

supplied) to connect the receiver to an
outdoor FM antennas (aerial) as shown
below.

Radio stations cannot be tuned in.

• Check that the antennas (aerials) are

connected securely. Adjust the
antennas (aerials) and connect an
external antenna (aerial), if necessary.

• The signal strength of the stations is

too weak with automatic tuning. Use
direct tuning.

• Make sure you set the tuning scale

correctly (when tuning in AM stations
with direct tuning) (page 53).

• No stations have been preset or the

preset stations have been cleared
(when tuning by scanning preset
stations is used). Preset the stations
(page 54).

• Press AMP, then press DISPLAY

repeatedly on the remote control so
that the frequency appears on the
display panel.

The sound is distorted.

• Press

2

– on the remote control

repeatedly. You can also use
MASTER VOLUME on the receiver.

• Set the “EQ” setting of the iPod/

iPhone to “Off” or “Flat”.

There is no sound from the iPod/
iPhone.

• Disconnect the iPod/iPhone and

connect the iPod/iPhone again.

The iPod/iPhone cannot be charged.

• Check that the receiver is turned on.
• Make sure the iPod/iPhone is

connected firmly.

The iPod/iPhone cannot be operated.

• Check that you have removed the

protect case of the iPod/iPhone.

• Depending on the contents of the iPod/

iPhone, it may take time to start
playback.

• Turn off the receiver, then disconnect

the iPod/iPhone. Turn on the receiver
again and reconnect the iPod/iPhone.

• You are using an unsupported iPod/

iPhone. See “Compatible iPod/iPhone
models” (page 47) for t
he supported
device types.

The ringtones volume of the iPhone
does not change.

• Adjust the ring volume using the

controls on the iPhone.

Are you using a supported USB
device?

• If you connect an unsupported USB

device, the following problems may
occur. See “Compatible USB devices”
(page 49)
for the supported device
types.

Tuner

Receiver

Outdoor FM antenna (aerial)

iPod/iPhone

USB device

Advertising