Sony STR-DN1040 - Manual (Page 37)

37 US
Prep
ari
n
g
th
e
Recei
ver
Setting the voltage
selector
If your receiver has a voltage selector on
the rear panel, check that the voltage
selector is set to the local power supply
voltage. If not, use a screwdriver to set the
selector to the correct position before
connecting the AC power cord (mains lead)
to a wall outlet.
Depending on the area, the VOLTAGE
SELECTOR may differ.
Connecting the AC
power cord (mains lead)
Connect the AC power cord (mains lead) to
a wall outlet.
Turning on the receiver
Press ?/1 to turn on the receiver.
You can also turn on the receiver using ? /1
button on the remote control. When you
turn off the receiver, press
? /1 again.
“STANDBY” flashes on the display panel.
Do not disconnect the AC power cord
(mains lead) while “STANDBY” is
flashing. This may cause a malfunction.
Setting up the receiver
using the Easy Setup
You can set the basic settings of the
receiver easily by operating the receiver in
accordance with the instructions on the TV
screen.
Switch the input of the TV to the input
which the receiver is connected.
When you turn on the receiver for the first
time or after the receiver is initialized, the
Easy Setup screen appears on the TV
screen. Proceed to set up the receiver in
accordance with the instructions on the
Easy Setup screen.
You can set up the following functions
using the Easy Setup.
– Speaker Settings
– Network Settings
Preparing the Receiver
AC power cord (mains lead)
To the wall outlet
?/1