Sony STR-DN1040 - Manual (Page 22)

22 US
The receiver is equipped with a function for converting video signals.
Video signals and component video signals can be output as HDMI video signals. As the
default setting, video signals input from the connected equipment are output as shown in
the table with solid arrows.
Notes on converting video
signals
• When video signals from a VCR, etc., are
upconverted on this receiver and then
viewed on your TV, depending on the
status of the video signal output, the
image on the TV screen may appear
distorted horizontally or no image can be
seen.
• If you are using an image improvement
circuitry with your VCR, it may impact
the video signal conversion. It is
recommended to turn off this function on
your VCR.
• Converted HDMI image output does not
support “x.v.Color (x.v.Colour)”, Deep
Color (Deep Colour), and 3D.
• HDMI video signals cannot be converted
to component video signals and video
signals.
• 1080p component video signals cannot
be upconverted.
Function for conversion of video signals
INPUT jack OUTPUT jack
HDMI IN
COMPONENT VIDEO IN
VIDEO IN
HDMI OUT
COMPONENT VIDEO MONITOR OUT
MONITOR OUT
: Same type of signal as that of the input signal is output.
: Video signals are upconverted and output (up to 4K).