Sony STR-DN1040 - Manual (Page 97)

97 US
Ad
jus
ting Se
tt
ing
s
• The surround back speakers will be set to the
same setting as that of the surround speakers.
x Test Tone
Lets you select the test tone type on the
“Test Tone” screen.
• To adjust the level of all speakers at the same
time, press
2
+/–. You can also use MASTER
VOLUME on the receiver.
• The adjusted value is shown on the TV screen
during adjustment.
To output test tone from each
speaker
You can output test tone from the speakers
in sequence.
1 Select “Test Tone”, then press .
2 Adjust the parameter, then press .
• Off
• Auto: The test tone is output from each
speaker in sequence.
• L, C, R, SR, SL, SB * , SBL, SBR,
FHL, FHR, SW: You can select which
speakers will output the test tone.
* “SB” appears when only one surround
back speaker is connected.
3 Adjust the speaker level, then press
.
x Center Speaker Lift Up
By using the front high speakers, you can
lift up the sounds of the center speaker to an
appropriate height on the screen, allowing
you to enjoy natural representation without
discomfort.
• 1 – 10
• Off
This function does not work in the following
cases.
– Headphones are connected.
– There is no center speaker.
– There are no front high speakers.
– The “2ch Stereo”, “2ch Analog Direct”, and
“Multi Stereo” sound field are being used.
– The sound field for music is being used.
x Distance Unit
Lets you select the unit of measurement for
setting distances.
• feet: The distance is displayed in feet.
• meter: The distance is displayed in
meters.
Audio Settings menu
You can adjust settings for the audio to suit
your preference.
x Digital Legato Linear (D.L.L.)
The D.L.L. function is Sony proprietary
technology that allows low quality digital
audio signals and analog audio signals to be
played back with high quality sound.
• Auto 1: This function is available for
lossy compression audio formats and
analog audio signals.
• Auto 2: This function is available for
Linear PCM signals, as well as lossy
compression audio formats and analog
audio signals.
• Off
• This function may not work, depending on the
content via a USB device, or a home network.
• This function works when “2ch Stereo”,
“A.F.D. Auto”, “Multi Stereo” or “Headphone
(2ch)” is selected. However, this function does
not work in the following cases.
– “FM TUNER” or “AM TUNER” input is
selected.
– Linear PCM signals with a sampling
frequency of other than 44.1 kHz are being
received.
– Dolby Digital Plus, Dolby Digital EX, Dolby
TrueHD, DTS 96/24, DTS-HD Master Audio,
or DTS-HD High Resolution Audio signals
are being received.
– During network function, signals with a
sampling frequency of other than 44.1 kHz is
being received.
Tips
Note
Notes