Sony STR-DN1040 - Manual (Page 99)

99 US
Ad
jus
ting Se
tt
ing
s
x Dynamic Range Compressor
Lets you compress the dynamic range of
the soundtrack. This may be useful when
you want to watch movies at low volumes
late at night. Dynamic range compression
is possible with Dolby Digital sources only.
• Auto: The dynamic range is compressed
automatically.
• On: The dynamic range is compressed as
intended by the recording engineer.
• Off: The dynamic range is not
compressed.
HDMI Settings menu
You can adjust the required settings for
equipment connected to the HDMI jacks.
x 4K Scaling
Lets you up-convert the video signals to 4K
and output through the HDMI OUT jacks
of the receiver.
• Auto: Enable video scaling control to 4K
HDMI output automatically if you
connect a 4K-compatible TV.
• Off: Does not activate this function.
This function works only when video signals
from VIDEO IN, COMPONENT VIDEO IN, and
HDMI IN jacks are being received. The HDMI
video input signals must be 1080p/24 kHz.
x Control for HDMI
Lets you turn the Control for HDMI
function on or off. For details, see
“Preparing for the “BRAVIA” Sync”
(page 82).
• On
• Off
• When you set “Control for HDMI” to “On”,
“Audio Out” may be changed automatically.
• When the receiver is in standby mode, the ?/1
(on/standby) indicator on the front panel lights
up in amber if “Control for HDMI” is set to
“On”.
x Pass Through
Lets you output the HDMI signals to the
TV even when the receiver is in standby
mode.
• Auto: When the TV is turned on while
the receiver is in the standby mode, the
receiver outputs HDMI signals from the
receiver’s HDMI OUT jack. Sony
recommends this setting if you use a
“BRAVIA” Sync-compatible Sony TV.
This setting saves power in the standby
mode when compared with the “On”
setting.
• On: When the receiver is in the standby
mode, the receiver continuously outputs
HDMI signals from the receiver’s HDMI
OUT jack.
• Off: The receiver does not output HDMI
signals when in standby mode. Turn on
the receiver to enjoy the connected
equipment’s source on the TV. This
setting saves power in the standby mode
when compared with the “On” setting.
• When the receiver is in standby mode, the ?/1
(on/standby) indicator on the front panel lights
up in amber if “Pass Through” is set to “On” or
“Auto”.
• When “Auto” is selected, it may take a little
more time for the image and sound to be output
to the TV than when “On” is selected.
x Audio Out
Lets you set the HDMI audio signals output
from the playback equipment connected to
the receiver via an HDMI connection.
• AMP: The HDMI audio signals from the
playback equipment are only output to
the speakers connected to the receiver.
Multi channel sound can be played back
as it is.
Audio signals are not output from the TV’s
speaker when “Audio Out” is set to “AMP”.
• TV + AMP: The sound is output from
TV’s speaker and the speakers connected
to the receiver.
Note
Notes
Notes
Note