Sony STR-DN1040 - Manual (Page 40)

40 US
• Make sure not to use the wireless LAN function
where medical equipment (such as a pacemaker)
is used or where the use of wireless
communication is prohibited.
• Before connecting to your home network, you
need to prepare a wireless LAN router/access
point. For details, refer to the operating
instructions of the device.
• Depending on your home network environment,
the wireless LAN router/access point may have
been set up such that it cannot be connected
using WPS, even though it is compatible with
WPS. For details on whether your wireless LAN
router/access point is compatible or not
compatible with WPS, and on the setup of a
WPS connection, refer to the operating
instructions of your wireless LAN router/access
point.
• You may encounter setup difficulties if the
receiver and the wireless LAN router/access
point are located too far from each other. If you
do, move the devices closer to each other.
Searching for an access
point and setting up a
wireless network (Access
Point Scan method)
You can set up a wireless network by
searching for an access point. To set up the
network using this connection method, you
will be required to select or enter the
following information. Check the
following information in advance, and
record it in the space provided below.
The network name (SSID
*
) that
identifies your network
**
. (This
will be needed in step 7.)
:
If your wireless home network is
secured by encryption, the
security key (WEP key, WPA/
WPA2 key) for your network
**
.
(This will be needed in step 8.)
:
* SSID (Service Set Identifier) is a name that
identifies a particular access point.
** This information should be available from a
label on your wireless LAN router/access
point, from the operating instructions, from
the person who set up your wireless network,
or from the information provided by your
Internet service provider.
1
Press AMP, then press HOME.
The home menu is displayed on the TV
screen.
2
Press B/b repeatedly to select
“Settings”, then press .
The Settings menu list appears on the
TV screen.
3
Press V/v/B/b repeatedly to select
“Network”, then press .
4
Press V/v repeatedly to select
“Internet Setting”, then press .
5
Press V/v repeatedly to select
“Wireless”, then press .
6
Press V/v repeatedly to select
“Access Point Scan”, then press
.
The receiver starts searching for access
points, and displays a list of up to 30
available network name (SSID).
7
Press V/v repeatedly to select the
network name (SSID) you want,
then press
.
The security setting display appears on
the TV screen.
Notes
HOME
DISPLAY
V/v/B/b,
AMP