Sony STR-DN1040 - Manual (Page 21)

21 US
Getting started
You can enjoy your audio/video equipment connected to the receiver by following the
simple steps below.
Before connecting cords, be sure to disconnect the AC power cord (mains lead).
Installing and connecting the speakers
(page 24, 26)
Connecting the TV and other equipment
(page 28, 29)
The image quality depends on the connecting
jack. See the illustration below. Select the
connection according to the jacks on your
equipment.
We recommend that you connect your
equipment via HDMI connection if they have
HDMI jacks.
Preparing the receiver
See “Setting the voltage selector” (page 37),
“Connecting the AC power cord (mains lead)”
(page 37) and “Turning on the receiver”
(page 37).
Setting the receiver
See “Setting up the receiver using the Easy
Setup” (page 37).
Analog
High quality image
Digital
Setting the audio output settings on the
connected equipment
To output multi channel digital audio, check the
digital audio output setting on the connected
equipment.
For a Sony Blu-ray Disc player, check that
“Audio (HDMI)”, “BD Audio MIX Setting”,
“Dolby Digital/DTS”, “Dolby Digital”, and
“DTS” are set to “Auto”, “Off”, “Bitstream”,
“Dolby Digital”, and “DTS” respectively (as of
August 1, 2012).
For a PlayStation 3, after having connected the
receiver with an HDMI cable, select the “Audio
Output Settings” in “Sound Settings”, and
select “HDMI” and “Automatic” (with system
software version 4.21).
For details, refer to the operating instructions
supplied with the connected equipment.