Revolution, Topside panel cable installation, Transforming the control of hot tubs – Balboa Water Group Revolution User Manual
Page 20
Revolution
Transforming the Control of Hot Tubs
20
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,
834 b2, Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
Plug-in Connector
J33 is for the
Topside Panel
J15: SPA LIGHT
BELEUCHTUNG
ECLAIRAGE BAIN HYDRO
10VAC 1A
S1
J45
J46
F4 3A 250V
J18
J19
K7
T1
J15
J33
J31 HCE
J30 TST
J27
H3
J22
J26 H2
J25 H1
J17
J16
J29 VAC
J28 AUX FRZ
J5
LIGHT
ON
22121_E
1
6
T
OPSIDE
P
ANEL
C
ONNECTOR
T
OPSIDE
P
ANEL
Topside Panel Cable Installation
Plug the
1.
panel connector into J33.
Route the panel connecting cable under the cable clamp.
2.
TIP
Allow for a drip-loop in the panel cable before it enters
the
enclosure.
Verify settings on the logic board.
3.
At this time, while the lid is off, check to see if any system configuration
4.
changes must be made. (See Advanced System Setup.)
TIP
The only configurations requiring a change would be:
Adding or removing a blower, or
t
Changing the operation voltage.
t
DRO
T1
J33