Balboa Water Group Revolution - Manual (Page 70)

Revolution
Transforming the Control of Hot Tubs
70
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,
834 b2, Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
1
S1
6
ON
2
1
Remove Lid
1. Shut off power. Remove Lid.
2. Place DIP switch No. 1 on the logic board to the ON position.
Software Setup
Note: Software Setup is changed through the panel, and is only necessary if
the wiring configuration is changed from factory default (Setup 1). If the factory
default had not been changed, this section can be skipped.
! A Power OFF, and then a Power ON is recommended during this
process. Upon power up, the No. 1 DIP switch on the logic board must
be set to S-1 (ON) for proper setup.