Silverline Rotary Laser Level Kit - Manual (Page 7)

6
GB
Alternative calibration method
1. Using a spirit level, mark a straight horizontal line on the wall at the
height required for your project
Checking the X Axis Vial
1. Position the Laser Level approximately 10m away from the wall,
ensuring that the X Axis Vial (10) is facing the wall
2. Turn the power on so that the Rotary Head spins to create a line on
the wall
3. Adjust the X Axis Levelling Screw (6) until the laser line matches the
line you have drawn on the wall
4. If the bubble is not in the centre of the X Axis Vial (10), use the
Screwdriver supplied (11) to adjust the vial until the bubble is centred
Checking the Y Axis Vial
1. Turn the unit through 90° so that the Y Axis Vial (4) is facing the wall
2. Repeat procedure as above, adjusting the Y Axis Levelling Screw (7)
Operating Instructions
Levelling
• Set up your rotary laser level in accordance with guidance in ‘Setting
Up’ section
• Ensure that the rotary laser is level by checking the vials and adjusting
the levelling screws. See ‘Calibrating Your Laser Level’ for guidance
• Turn power on and use the control button to establish the correct speed.
• Mark the desired positions
Plumbing
• Set up your rotary laser level in accordance with guidance in ‘Setting
Up’ section
• Ensure that the rotary laser is level by adjusting the Y levelling screw until
the plumbers vial bubble is centred
• Turn power on and use the control button to establish the correct speed
• Mark the desired positions
• It is also possible to operate the unit manually: switch on the unit and
turn the unit by hand until the laser beam is aligned with your target
Maintenance
WARNING: Always remove the plug from the mains power supply before
carrying out any maintenance/cleaning.
Cleaning
• Keep your machine clean at all times. Dirt and dust will cause internal
parts to wear quickly, and shorten the machine’s service life. Clean the
body of your machine with a soft brush, or dry cloth. If available, use
clean, dry, compressed air to blow through the ventilation holes
Disposal
• Do not dispose of power tools, or other waste electrical and electronic
equipment, with household waste
• Contact your local waste disposal authority for information on the proper
way to dispose of tools
273233_Z1MANPRO1.indd 6 06/10/2011 15:00