Festo Кабели и принадлежности - Manual (Page 28)

©
ª
«
Direction for unlocking
Locks automatically
Safety catch
¬
­
®
Front plate of module
Terminal strip
Guide rail
Fig. 2/1: Fitting the modules
When removing a module, proceed as follows: Removing
modules
1. Switch off the operating voltage and the compressed
air supply.
2. Disconnect and remove the cable on the front of the
module.
3. Unlock both safety catches (see Fig. 2/1) and care-
fully remove the module.
4. If necessary, seal unused slots with blanking plates.
® ­ ©
¬
ª
©
«
«
2. Fitting
2-6 SPC200-COM-IBS 0503a