Festo Кабели и принадлежности - Manual (Page 41)

Program test in record select mode
In record select mode, the window "Control signals"
enables the direct selection of an NC record number.
This NC record number corresponds to the actual NC
record number in the NC program.
Please note that when loading a program with
WinPISA, the programmed record numbers are stored
beginning with N000 and with step size 1.
Example 1: Start NC record from line N007 of program A
' = 1-signal
©
ª
Start NC record with CLK_A signal
Current NC record number (here 7)
«
Entry field for NC record number
(conclude entry with ENTER)
Fig. 4/2: Selecting an NC record in record select mode (example)
©
«
ª
4. Commissioning
SPC200-COM-IBS 0503a 4-7