Festo Кабели и принадлежности - Manual (Page 59)

4.4 Addressing the SPC200 on the INTERBUS
4.4.1 General information
Further information on addressing can be found in the
manuals for your controller and the INTERBUS module.
The address assignment (process data assignment) of
the inputs and outputs of an SPC200 on the
INTERBUS or on systems compatible thereto depends
primarily on the INTERBUS module and on the control
system used.
CAUTION
There are different address assignments on the
INTERBUS. The reason for this is the assignment of
the process data within the INTERBUS module and
not within the SPC200.
– Note with the assignment of the addresses the
position of the high and low bytes, as on some
control systems the position of these bytes may
be swapped.
You can thereby avoid errors when addressing the
SPC200.
4. Commissioning
SPC200-COM-IBS 0503a 4-25