Asante Technologies 5308F - Manual (Page 32)

Installation
Page 2-4
Rack Mounting/
Desktop
Placement
The IntraSwitch 5308FL can be installed in a standard 19-inch
equipment racks. It can also be placed on a horizontal surface
with support capabilities of 11 pounds (5 kilograms).
Equipment Rack
Installation
To install the IntraSwitch 5308FL in an equipment rack:
▲
Important! Disconnect all cables from the
IntraSwitch 5308FL before continuing.
1 Place the IntraSwitch 5308FL on a stable, flat surface.
2 Locate a rack-mounting bracket (supplied) and
place it over the mounting holes on one side of
the unit, as shown in Figure 2-1.
Figure 2-1 Mounting rack bracket on the IntraSwitch 5308FL
3 Insert four screws (supplied) into the holes and
tighten with a Phillips screwdriver.
4 Repeat the two previous steps for the unit’s
other side.
5 Place the IntraSwitch 5308FL in the equipment rack.
▲
Important! Make sure the IntraSwitch 5308FL
is supported until all four mounting screws for
each bracket are secured to the equipment rack.
IntraSwitch 5308FL
100 Mbps
Max Util
FDP / COL
Data
Link
10/100 1 2 3 4 5 6 7 8 MII 1 MII 2
10/100
Console
RS-232
1 2 3 4 5 6 7 8