Asante Technologies 5308F - Manual (Page 74)

Console Management
Page 5-18
Configure SNMP Parameters
This menu controls the IntraSwitch 5308FL’s SNMP (Simple
Network Management Protocol) parameters.
With these parameters, you can configure the IntraSwitch
5308FL’s read and write community strings, set the IntraSwitch
5308FL to generate authentication traps, and determine which
management stations on your network can receive traps.
To access the SNMP Parameter Menu, type n from the
Configuration Menu. The following menu appears:
Figure 5-7 SNMP Parameter Menu
Current Settings
Table 5-8 explains each setting on the SNMP Parameter
Menu.
For information on using the menu, see:
❏ “Setting Community Strings” — page 5-20
❏ “Enabling Trap Authentication” — page 5-20
❏ “Adding a Trap Receiver” — page 5-21
❏ “Deleting a Trap Receiver” — page 5-21
Current Settings