Asante Technologies 5308F - Manual (Page 89)

Configure Spanning Tree Parameters
Page 5-33
3 Select the port number you want to enable
or disable Spanning Tree on by typing
l on
the Port Parameter Menu and entering the
port number at the prompt.
∆
Note: The 10/100TX port is port number 9,
the MII ports (MII I and MII 2) are port num-
bers 10 and 11, respectively.
4 Press return.
5 Type e to enable Spanning Tree on the port;
type d to disable Spanning Tree on the port.
6 Type q to exit this menu and return to the
Spanning Tree Parameter Menu.
7 Type a to apply the changes.
▲
Important! The change will not take
effect until
Apply is selected from the Span-
ning Tree Parameter Menu.