Asante Technologies 5308F - Manual (Page 93)

Reset EEPROM to Default
Page 5-37
Reset EEPROM to Default
This option resets the IntraSwitch 5308FL’s values to the
factory default.
▲
Important! This procedure reverts all informa-
tion to the factory default settings
except for
the IntraSwitch 5308FL’s IP address, subnet
mask, and default gateway.
See “Factory Defaults” on page 1-11 for a list of
all the IntraSwitch 5308FL’s factory default set-
tings.
To reset the EEProm:
1 Type e from the Configuration Menu.
The following command line appears at the bot-
tom of the Configuration Menu:
Figure 5-16 Reset EEProm to Default command line
2 Type y to reset the EEPROM to default or N to
cancel the reset.
3 Reset the IntraSwitch 5308FL by manually turn-
ing it off and then on again.
The IntraSwitch 5308FL’s EEPROM is reset.