Lenovo ThinkPad Edge 15 - Manual (Page 32)

: Silent install using the MSI with a reboot
: Type the following command on one line
start /WAIT msiexec /i "C:\TVTRR\Rescue and Recovery.msi" /qn
With reboot suppressed, enter the following command:
: Silent install using the MSI without a reboot
: Type the following command on one line
start /WAIT msiexec /i "C:\TVTRR\Rescue and Recovery.msi" /qn REBOOT="R"
3. Enter the following commands:
: Start the Rescue and Recovery Service
net start "TVT Backup Service"
: Create Sysprep Base Backup to Local Hard Drive
: Type the following command on one line
cd "\Program Files\Lenovo\Rescue and Recovery"
rrcmd sysprepbackup location=l name="Sysprep Backup"
If you want to use a password, add the syntax password=pass.
4. Run your specific Sysprep implementation when you see the following message:
***************************************************
** Ready to take sysprep backup.
**
** PLEASE RUN SYSPREP NOW AND SHUT DOWN. **
** **
** Next time the machine boots, it will boot **
** to the Predesktop Area and take a backup. **
***************************************************
5. Shut down and reboot the system when Sysprep backup is complete. .
Note: The operating system will reboot into the Predesktop Area of the Rescue and Recovery program.
The status bar with the message “System Restore in Progress” will be displayed.
6. Restart the system.
7. Capture the image for deployment.
Capturing a multiple partition system and excluding files in a Sysprep backup
To capture multiple partitions in a Sysprep utility backup, do the following:
1. Perform an administrative installation action:
:: Extract the WWW EXE to the directory C:\TVTRR
start /WAIT z696zisus00xxxx.exe /a /s /v"/qn TARGETDIR
(where XXXX is the build ID)
="C:\TVTRR" REBOOT="R"" /w
2. Add the following command to the end of the rnrdeploy.xml file in C:\tvtrr\Program Files\Lenovo\Rescue
and Recovery:
<Rescue__and__Recovery..Settings..Backup path
="Rescue and Recovery\Settings\Backup">
To exclude a partition, add the following to the rnrdeploy.xml file:
24 Rescue and Recovery 4.23 Deployment Guide