Lenovo ThinkPad Edge 15 - Manual (Page 48)

Button00=[0-10], "title", file.bmp, [0 or 1] This setting directs the environment to display or
hide the entry. The value 0 hides the entry. If the
value is set to 0, then a blank line is displayed. The
value 1 displays the entry.
Button00=[0-10], "title", file.bmp, [0 or 1], 1 This is a reserved function and must always be set
to 1.
Button00=[0-10], "title", file.bmp, [0 or 1], 1, [0 or 1] To require a password prior to starting an
application, place a value of 1 in this position. If you
set this value to 0, no password is required before
a specified application is started.
Button00=[0-10], "title", file.bmp, [0 or 1], 1, [0 or
1], %tvtdrive%[pathname\executable]
The value of %tvtdrive% must be the boot drive
letter. Following the boot drive letter, you must
provide a fully qualified path to an application or
command file.
Button00=[0-10], "title", file.bmp, [0 or 1], 1, [0 or
1],%tvtdrive%[pathname\executable], [parameters]
Provide the parameters required by the target
application that is being started.
If you are not providing values for various fields, you must provide the required commas in order for the
button definition to be accepted and to run correctly. For example, if you are creating a group heading,
"Rescue and Recover," the following would be the code for the entry:
Button04=1, "Rescue and Recover",,,,,,
Entries 02, 07, 11 and 16 must remain type 0 (or header) entries, and they always fall in their numerical
places. The availability of entries that fall under the headers can be disabled by setting fully customizable
entries to type 0-blank lines in the left panel. However, the total number of entries cannot exceed 23.
The following table shows the function and executable that you can start from the left-panel entries:
Table 20. Left-panel functions and executables
Function Executable
Recover files WIZRR.EXE
Restore from backup WIZRR.EXE
Create migration file WIZRR.EXE
Open browser OPERA.EXE
Map a network drive MAPDRV.EXE
Diagnose hardware PCDR.CMD
Create diagnostic diskettes DDIAGS.CMD
Note: The PCDR.CMD executable helps launch the PC Doctor application that is only provided for the
Lenovo-branded preinstallation models.
Changing entries and functions in the right panel
Changing the right-panel entries requires that the pdaguixx.ini file is edited, where xx is the language
designation. For information about getting pdaguixx.ini from the Rescue and Recovery environment and
replacing the file, see the example provided in “Using the pdaguixx.ini configuration file” on page 37.
40 Rescue and Recovery 4.23 Deployment Guide