Lenovo ThinkPad Edge 15 - Manual (Page 29)

Advanced settings are used to define one or more commands that can be run at the first time when a user
logs on to his or her system.
Command line interface
The following executable supports a command line interface for the Base Software Administrator program
and is supported under WinPE and the Windows environment:
TBSADMIN.EXE [/DEPLOY [/SILENT] [/BOOTSP=YES|NO]
[/MANIFEST="<path>"] [/PERSONALIZATION="<path>"]]
The following table provides the switches for the Base Software Administrator program.
Table 12. Switches
Switch Description
/DEPLOY Required to trigger a deployment. If /BOOTSP, /MAN
or /PER is also specified, the deployment wizard is not
displayed.
/SILENT Suppresses any message boxes for error or successful
completion. (For return codes, see the following table.)
/BOOTSP Takes an explicit Y or N value to indicate whether the
service partition should be set active, for example
/BOOTSP=Y. A value of N allows the administrator to
reset the C: partition active again, so recovery does not
automatically occur on next reboot.
The executable returns the following codes:
Table 13. Return codes
Return code Return message
0 Success
1 Unable to access service partition
2 Error copying manifest file into service partition
3 Error copying personalization file into service partition
4 Error deleting file from service partition
5 Error writing AUTO.TAG file in service partition
6 Error setting service partition active
Backups
The following sections provide customization information for Rescue and Recovery backups.
Scheduling backups and associated tasks
The scheduler is not designed to be specific to the Rescue and Recovery program; however, the
configuration is stored in the registry. When the Rescue and Recovery program is installed, it will populate
the scheduler with the appropriate settings.
The following is a description of the structure of the scheduler:
• Location: C:\Program Files\Common Files\Lenovo.
Chapter 3 . Configurations 21