Konica Minolta bizhub 4750 User Manual

Page 39

Advertising
background image

1.5

Available operations in Administrator mode

1

[Applied Functions]

1-33

8

From [IPsec Policy] on [IPsec] screen, click [Edit], then configure the following settings.

9

In the administrator mode, select [Security] - [IPsec] - [Communication Check], then check that a con-
nection with a peer can be established normally by the specified setting.

% Enter the peer's IP address into [IP Address], then click [Check Connection].

[Cookies]

Select whether or not to enable the defense using Cookies against denial-of-
service attacks.
[Disable] is specified by default.

[ICMP Pass]

Select whether or not to apply IPsec to the Internet Control Message Protocol
(ICMP).
Select [Enable] to allow the ICMP packets to pass without applying IPsec to
the ICMP.
[Enable] is specified by default.

[ICMPv6 Pass]

Select whether or not to apply IPsec to the Internet Control Message Protocol
for IPv6 (ICMPv6).
Select [Enable] to allow the ICMPv6 packets to pass without applying IPsec to
the ICMPv6.
[Enable] is specified by default.

[Default Action]

Select an action to be taken if no settings meet the [IPsec Policy] while IPsec
communication is enabled.
Select [Deny] to discard IP packets that do not meet the [IPsec Policy] settings.
[Allow] is specified by default.

Item

Description

[Name]

Enter a name for the IPsec policy (using up to 10 characters).

[Peer]

Select a peer setting.
Select the setting from those registered in [Peer] on the [IPsec Settings]
screen.

[Protocol Setting]

Select an appropriate protocol.
Select the setting from those registered in [Protocol Setting] on the [IPsec Set-
tings] screen.

[SA]

Select a peer setting.
Select the setting from those registered in [SA] on the [IPsec Settings] screen.

[Communication Type]

Select a direction of IPsec communication.

[Action]

Select an action to be taken for the IP packets that met [Peer], [Protocol Set-
ting], and [Communication Type].

[Protected]: Protect the IP packets that met the conditions.

[Allow]: Do not protect the IP packets that met the conditions.

[Deny]: Discard the IP packets that met the conditions.

[Refuse]: Refuse the IP packets that met the conditions.

Item

Description

Advertising
This manual is related to the following products: