Konica Minolta bizhub 4750 - Manual (Page 50)

[Applied Functions] 1-44
1.5 Available operations in Administrator mode 1
[Text]
To display: Administrator mode - [Address] - [Text] - [Text List]
Enables you to register body messages that are used when sending E-mails. Also, it enables you to confirm
or edit the registered information of the body that is saved on this machine.
To register message text, click [Edit], then enter message text to be registered (using up to 256 characters).
Tips
- Up to 10 bodies can be registered, and a body can be selected from them before transmission.
- By selecting [E-mail Default] in the body list, you can specify the default body that is used for E-mail
transmission.
1.5.7 [Network] tab
[General Settings] - [Ethernet Settings]
To display: Administrator mode - [Network] - [General Settings] - [Ethernet Settings]
Specify the network speed, and check the MAC address.
[General Settings] - [Local Interface Settings]
To display: Administrator mode - [Network] - [General Settings] - [Local Interface Settings]
Change the time-out time to limit a communication with the computer.
[TCP/IP Settings] - [TCP/IP Settings]
To display: Administrator mode - [Network] - [TCP/IP Settings] - [TCP/IP Settings]
Configure the TCP/IP settings.
Item Description
[Speed/Duplex] Select the network speed according to your environment. Selecting [Auto] en-
ables communication in all network environments.
[100Mbps Half Duplex] is specified by default.
[MAC Address] Displays the MAC address of the network interface card of this machine.
Item Description
[I/O Timeout] When this machine is connected via a USB device to the computer, change the
communication time-out time if necessary.
[60] sec. is specified by default.
Item Description
[TCP/IP] Select whether or not to use TCP/IP.
[Enable] is specified by default.
[LPD] Select whether or not to use LPD (Line Printer Daemon).
[Enable] is specified by default.
[SLP] Select whether or not to use SLP (Service Location Protocol).
[Enable] is specified by default.
[LLMNR] Select whether or not to use LLMNR (Link-local Multicast Name Resolution).
[Enable] is specified by default.