Konica Minolta bizhub PRESS C1060 - Manual (Page 202)

Parameter Option Description
Gray Use protected gray values—Retains gray colors as defined in the
Spot Color Editor.
Calibration Linked Uses the calibration table that was created for the media type and
screening method selected for your job
Normal This table is used if a calibration table has not been created for the
media type, weight, and screening method that you are using. You
cannot edit this calibration table.
None Does not apply a calibration table when jobs are processed and
printed.
Photo touch-up tab in the job parameters window
Apply the most effective image enhancement, and fine-tune
images for reproduction
Note: The Photo Touch-up option is available only with the Match Pack.
Parameter Option Description
Photo touch-
up Apply photo
touch-up
options Enables you to apply the photo touch-up options:
● Exposure and color cast—Corrects underexposure,
overexposure, and minor color-cast problems in photos.
● Image noise—Reduces noise (such as granularity caused by
high ISO settings) in a photo.
● Shadows and highlights—Brings out details in the dark and light
areas of a photo.
● Red-eye—Removes the red-eye effect in photos taken with a
flash.
● JPEG artifacts—Removes JPEG artifacts often found in low-
quality or highly compressed JPEG files, particularly in gradient
and vignette areas and around the edges of objects.
Finishing tab in the job parameters window
Apply these settings to specify how to finish your job.
Parameter Option Description
Finishing Lists the available finisher options. This list depends on the modules
that are installed on the printer.
Stapler sub
tray Multi hole punch—This option is available only if the multi hole
punch module is connected.
192 Chapter 11—Job parameters