Konica Minolta bizhub PRESS C1060 - Manual (Page 56)

1. From the Tools menu, select Calibration or select the
Calibration icon on the toolbar.
2. From the Measuring device drop-down list. select FD-5.
The following message appears while the IC-309 print
controller connects to the FD-5.
To enable the IC-309 print controller to connect to the FD-5,
you must now perform a white calibration on the FD-5, as
follows:
a. Attach the FD-5 to the Target Mask.
b. Correctly set the device on the White Calibration plate that
has the same pairing number as the device.
46 Chapter 3—Calibration