Konica Minolta bizhub PRESS C1060 - Manual (Page 206)

Parameter Option Description
● Punch—The values vary according to the type of punch unit
connected. The number of holes is 2, 3, or 4.
Multi Tri-fold-
in
Saddle stitch
sub tray Multi hole punch—This option is available only if the multi hole
punch module is connected.
Saddle stitch
main tray ● Center Staples—Staples the center of the booklet
● Trim
Stacker Sub
Tray Multi hole punch—This option is available only if the multi hole
punch module is connected.
Stacker Main
Tray ● Multi hole punch—This option is available only if the multi hole
punch module is connected.
● Offset
● Sample print—Enables you to print extra pages to an easily
accessible output tray during a long print job and verify that the
printer is performing as expected. For example, when a job is
currently printing to a closed elevator (such as, 1000 pages to an
output tray that cannot be opened until the entire job is
completed), you can use the sample print function to print a
separate page or finished output set to an open output tray to
verify the output. If the output is unsatisfactory, you can take
corrective action.
Perfect binder
sub tray Multi hole punch—This option is available only if the multi hole
punch module is connected.
196 Chapter 11—Job parameters