Konica Minolta bizhub PRESS C1060 - Manual (Page 95)

Troubleshooting profiling
Resolve common problems that can occur during the profiling
process.
Message Information and solution
Wrong
measured strip The data received for the measured strip does not
match the expected results for this strip.
Make sure that you are measuring the correct strip.
Perform one of the following actions:
● Click OK to measure the strip again.
● Click Cancel to continue the process.
Strip
measurement
failed A red X icon appears.
Repeat the measurement.
Device not
connected Connect the external device.
Printer not
connected Connect the printer.
Measurement
failed Repeat the measurement.
Invalid
measurement
format loaded Make sure that you are loading a measurement file in
the correct file format.
Wrong chart
measured Repeat the measurement with the correct chart.
Managing profiles
The Profile Manager enables you to import and manage
destination, source, and device link profiles on the IC-309 print
controller.
Importing a destination profile
Import a destination profile to emulate an output device.
Requirements:
If you save a profile in a location other than the Profile Manager,
you must import it before you can print a job using it.
Note: After you import the profile, the file format becomes *.icm.
Troubleshooting profiling 85