Konica Minolta Magicolor 7300 - Manual (Page 157)

Lower Feeder Units (Trays 3 and 4) 149
Lower Feeder Units (Trays 3 and 4)
The optional lower feeder units increase your printer's media feed capacity by
up to 1,000 11"x17"/A3 sheets.
A maximum of two optional lower feeder units may be installed.
Kit Contents for Each Unit
a Lower feeder unit with
500-sheet media tray
b Four fixing plates (two
in front, two in rear)
per lower feeder unit
c One shoulder screw
for each fixing plate
d One mounting bracket
per lower feeder unit
e Two securing screws
for bracket d
f Control harness with
12-pin and 11-pin
connectors
g Power supply
harness A (with
core
attached) (for
a DC24V connection)
h Power supply harness B (with no core attached)
(for a DC24V extension)
i Media size labels
Installing the Lower Feeder Unit(s)
Attention
Since consumables are installed in the printer, be sure to keep the
printer level when moving it in order to prevent accidental spills.
1
Turn off the printer, and unplug the power cord and interface cable(s).
2
Remove each lower feeder unit kit from the shipping carton, and place the
contents on a table or flat surface near the printer.
a
d
e
c
b
f
g
h i