Konica Minolta Magicolor 7300 - Manual (Page 238)

Safety Information 230
Laser Safety Label—IEC60825-1 Requirement
Laser Caution For United States Users—CDRH Regulations
This printer is certified as a Class I laser product under the Regulation Performance Standard according to
the Food, Drug, and Cosmetic Act of 1990. Compliance is mandatory for laser products marketed in the
United States, and is reported to the Center for Devices and Radiological Health (CDRH) of the U.S. Food
and Drug Administration (FDA) of the Department of Health and Human Services (DHHS). This means
that the product does not produce hazardous laser radiation. The label shown below indicates compliance
with the CDRH regulations and must be attached to laser products marketed in the United States.
Laser Safety Label—CDRH Requirement
CAUTION : Use of controls, adjustments, or performance other than
those specified in this manual may result in hazardous radiation
exposure.
This is a semiconductor laser. The maximum power of the laser diode is 15 mW, and the wavelength is
770–800 nm.
International Notices—Power Cord
The following power cord requirements are in effect for your 220~240 V ±10% printer.
Minimum: 0.75 mm 2
Minimum: H05 VV - F
The male plug is certified in the country in which the equipment is to be installed, and the female plug is an
IEC 60320 connector.