Konica Minolta Magicolor 7300 - Manual (Page 169)

Lower Feeder Units (Trays 3 and 4) 161
19
Secure the power supply harness A
with the cable holder so that the core is
between the cable holders on Tray 2’s
unit.
20
Plug the black 3-pin connector of
power supply harness B (with no core
attached) into a black socket at the
back of the printer.
The 3-pin connector (black socket)
can be plugged into any of the three
sockets on the printer. As an
example, the illustration at the right
shows the connector plugged into
the upper-left connector.
21
Plug the other end of that black 3-pin
connector on the power supply
harness B into the black 3-pin socket
on a power supply harness A (with the
core attached). Then, plug the power
supply harness A’s 2-pin white
connector into the white PJ6 socket on
Tray 3’s unit.