Konica Minolta BIZHUB PRO 1050 - Manual (Page 375)

14
Utility Tool
14-29 bizhub PRO 1050
14.4 Netware
This printing system works with IPX/SPX (Internetwork Packet Exchange /
Sequenced Packet Exchange).
This section explains how to configure a NetWare File Server, a NetWare
Print Server, and a NetWare queue.
The print controller supports the system environment described below.
Setup for NetWare 3.x
Before setting up NetWare, you have to define the print server name, etc.,
from the Web Utilities.
The setup procedure of NetWare 3.x is as follows. To perform this procedure,
you need authorization to perform this procedure.
1
Start up PCONSOLE and select the file server to use.
DETAILS
Refer to the manual of Novell NetWare for setting up with PCONSOLE.
2
Generate and assign a print queue.
3
Define the network interface card as the print server.
4
Define the notification list/password as necessary.
5
Set up the primary file server as necessary.
On completion of setup, turn off the main power of the print controller and
the main body printer and turn it on again.
The main body printer will print out a Status Page indicating the file servers
equipped with print server and the queues that the file servers will service.
Note
Define the primary file sever if the network connects to many sites and
has more than one file server. PCONSOLE should be used to set up the
primary file sever.
NetWare Version Protocol Emulation Service Mode
NetWare 3.2 IPX Bindery Pserver/Rprinter
NetWare 4.x IPX NDS Pserver/Nprinter
NetWare 5.x
NetWare 6
IPX NDS Pserver
TCP/IP NDPS(lpr)