Konica Minolta BIZHUB C30P - Manual (Page 36)

Installing MetaConsole
page 22
3 The Setup Program screen opens. Click Next to continue.
4 Accept the Licensing Agreement. You cannot install and use MetaConsole if you do not
accept the agreement. Click Next.
5 Select Custom installation from the drop-down menu.
6 Select the following items:
• MetaConsole Server
• MetaConsole Snap-in for MMC
Note :The Konica Minolta PageScope EMS Plug-Ins will always be installed. You may not
customize these components.
7 Click Next.
8 Specify a Destination Folder. The default folders specified below are recommended:
• Windows: C:\Program Files\PageScope EMS Plug-Ins
• HP-UX, Linux and Solaris: /opt/PageScope EMS Plug-Ins
If you prefer a different folder, click Choose... and browse to the folder. When the selection
has been made, click Next.
9 [MetaConsole Server] Specify a TCP/IP port number. Click Next.
10 The Pre-Installation Summary screen opens. This screen lists the installation options
you have selected. If any options are incorrect, click the Previous button to return back
and edit your selection(s). When you have completed this, return to the Pre-Installation
Summary screen, reverify your new settings, then click Install.
11 The Installation Progress screen appears as MetaConsole installs.
12 When installation finishes, a final screen appears, notifying you that the installation has
been successfully completed.
13 Click Done to exit the Installation program.
Starting the MetaConsole Server after Installation
Note :The MetaConsole installation procedure does not start the MetaConsole server. To
use the MetaConsole Server immediately after installation, you must manually start it.
To manually start the MetaConsole Server on Windows, follow this procedure:
1 Click the Start button, point to Programs then point to PageScope EMS Plug-Ins.
2 Do one of the following:
• To run the MetaConsole Server as a program, click Run PSEMS.
• To run the MetaConsole Server as a Windows service, click StartService.