Konica Minolta BIZHUB C30P - Manual (Page 54)

Configuring MetaConsole
page 40
Specifying Pager Notification Settings
To specify settings for pager notification, follow this procedure:
1 In the OpenView map, right-click a node that is managed by the MetaConsole OpenView
snapin, and on the menu that appears, click MetaConsole Configuration. A MetaConsole
client browser window opens (Figure 2.1).
2 In the navigation pane, expand the Configuration node and click Alarm Notification
Methods. The Alarm Notification Methods screen opens (Figure 2.3).
3 Click the Settings . . . button next to the Pager check box. The Pager Notification Set-
tings appear at the bottom of the details pane (Figure 2.5).
Figure 2.5: OpenView Pager Notification Settings
4 Specify primary recipients by doing one or both of the following:
• To add a recipient to the Pager List:
a. In the Pager ID box, type a pager ID (typically a 10- or 11-digit phone number).
b. In the Pager Service list, click the name of the paging service to be used.
c. Click the adjacent Add button.
• To remove a recipient from the Pager List: Click the pager ID; then click the adjacent
Remove button.
5 In the From box, type the email address that will appear as the originator of all alarm page
messages sent by MetaConsole. Typically, this is a network administrator’s email address.