Gradall 544D (9136-4003) Service Manual - Manual (Page 11)

Form No. 20220 z z z z z 544D-10 Owner/Operator Manual
1.1
Keep all windows and mirror(s) clean. Adjust mirror(s) as required for maximum
visibility, before and during operation.
Never permit diesel engine to run out of fuel. Doing so can cause severe
engine damage.
DO NOT burn or drill holes in forks. Modifying any part of machine or
attachment may affect machine capacity and/or stability.
Keep head, arms, hands, legs and all other body parts inside the operator’s
cab at all times.
DO NOT approach power lines, overhead or underground cables or other power
sources with any part of your material handler or load unless all local, state/
provincial and federal regulations have been met and the appropriate utility
company has been contacted to de-energize the lines.
Whenever leaving the cab, perform standard shut-down procedure:
Standard Shut-Down Procedure
Position the handler in a safe location, apply parking brake, lower forks to
ground, move all controls to “Neutral”, allow engine to run at low idle for 3 to 5
minutes. Stop engine and remove ignition key. Block wheels.
Pinch Points
Stay clear of pinch points and rotating parts on the material handler.
Getting caught in a pinch point or a moving part can cause serious
injury or death. Before performing any maintenance on machine, follow
the “STANDARD SHUT-DOWN PROCEDURE”.
Contact The Gradall Company prior
to welding on machine.
WARNING !
Rear Steering Axle Boom
Boom Holes Attachment Tilt
Carriage Forks Stabilizers