Gradall – Gradall 544D (9136-4003) Service Manual User Manual

Page 317

Advertising
background image

5.1

R

ETRACT

C

HAIN

R

EINSTALLATION

Lubricate and inspect chains thoroughly before installation. See Section 6 Articulate the

chains to make sure all working surfaces ore thoroughly lubricated.

Note! Install the 3/4" chain first.

3

/

4

" Chain Reinstallation

Fasten a rope to the end of the 3/4" chain in order pull it back into the boom.

Attach the choin to the chain clevis at the rear of boom-section 4.

Carefully pull the chain into the boom until it can be fastened to the chain clevis.

Remove the rope.

Fasten the chain into the clevis by installing a pin and colter pin.

Install and torque the jam nut to 100 ft-lb. Do not use LOCTITE

®

on the nuts.

1" Chain Reinstallation

For the 1" chain, perform Steps 1 through 5 per above.

Install the chain adjustment block and mounting bolts removed under

“Removal”, Step 1, Page 5.0

Torque the mounting bolts to 340-365 ft-lb.

Readjust the chains.

Install and torque the jam nut to 100 ft-lb. Do not use LOCTITE on the nuts.

R

EMOVING THE

E

XTEND

C

HAINS

W

ITHOUT

R

EMOVING THE

B

OOM

A

SSEMBLIES

Preparation

Extend the boom far enough to access the chain anchor and the clevis through

the rear top access hole.

Mechanically secure the boom sections together to prevent

uncontrolled boom runout when the extend chains are removed.

Removal

On the chain being extracted, remove the jam nut from the rear chain clevis and

back off the adjusting nut on the chain clevis fully without removing it.

Remove the chain clevis pin and the cotter pin to free the chain.

Install a plastic tie-wrap through the chain holes, forming a loop and tie rope to

the loop.

Pull slack to the chain clevis at the front of the boom.

Remove the devis pin and the colter pin from the chain and the chain clevis.

Install a plastic tie-wrap through the chain holes, forming a loop and tie a rope

to the loop.

Carefully pull the chain out of the boom.

1.

2.

3.

4.

5.

6.

1.

2.

3.

4.

5.

1.

2.

1.

2.

3.

4.

5.

6.

7.

Note!

Use front or rear, whichever best

suits the particular situation.

(Typically, the chain is pulled out

through the rear access hole)

R

EAR

, B

OOM

-S

ECTION

4 &

R

EAR

, B

OOM

-S

ECTION

3

E

XTEND

C

HAINS:

R

EMOVAL

E

XPLOSION

GRADALL

GRADALL

Advertising