Apple Final Cut Pro X (10.0.9) - Manual (Page 319)

Chapter 11 Advanced editing 319
Switch video or audio separately
By default, Final Cut Pro switches the video and audio of a multicam clip at the same time. But
you can set Final Cut Pro to switch the video and audio separately.
1 To open the Angle Viewer, choose Window > Viewer Display > Show Angles (or press
Command-Shift-7).
2 To change the switch mode, do one of the following:
•
To enable video and audio switching: Click the left switch mode button in the upper-left corner
of the Angle Viewer. This is the default setting.
Click to enable video
and audio switching.
Yellow highlighting indicates
that both the active video
and the active audio are
contained in one clip.
The bank switcher
shows the active angle.
•
To enable video-only switching: Click the middle switch mode button. Only the video switches.
The audio from the original angle remains active.
Click to enable
video-only switching.
•
To enable audio-only switching: Click the right switch mode button. Only the audio switches.
The video from the original angle remains active.
Click to enable
audio-only switching.
3 Do one of the following:
•
To cut and switch: Click an angle in the Angle Viewer.
•
To switch: Option-click an angle in the Angle Viewer.