JLG 1100SB Operator Manual - Manual (Page 33)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121264 – JLG Lift – 3-1
SECTION 3. MACHINE CONTROLS AND INDICATORS
3.1 GENERAL
THE MANUFACTURER HAS NO DIRECT CONTROL OVER MACHINE
APPLICATION AND OPERATION. THE USER AND OPERATOR ARE
RESPONSIBLE FOR CONFORMING WITH GOOD SAFETY PRACTICES.
This section provides the necessary information needed to
understand control functions.
3.2 CONTROLS AND INDICATORS
NOTE: This machine is equipped with control panels that use
symbols to indicate control functions. Refer to decal
located on the control box guard in front of the control
box or by the ground controls for these symbols and the
corresponding functions.
TO AVOID SERIOUS INJURY, DO NOT OPERATE MACHINE IF ANY CON-
TROL LEVERS OR TOGGLE SWITCHES CONTROLLING PLATFORM
MOVEMENT DO NOT RETURN TO THE OFF POSITION WHEN RELEASED.
Ground Control Station
NOTE: The Function Enable switch must be held
down in order to operate Telescope, Swing,
Main Lift, Jib Lift, Platform Level Override,
and Platform Rotate functions.
(See Figure 3-1., Ground Control Station)
1. Indicator Panel
The LED Indicator Panel contains indicator lights that
signal problem conditions or functions operating during
machine operation.
2. Boom Control System Test Button
The push button is used to test the boom control system
and confirm that it is working properly.
3. Telescope Control
Provides extension and retraction of the boom when
positioned to IN or OUT.