JLG 1100SB Operator Manual - Manual (Page 61)

SECTION 4 - MACHINE OPERATION
3121264 – JLG Lift – 4-11
Swinging the Boom
To swing boom, use Swing control to select Right or Left
direction.
WHEN SWINGING THE BOOM MAKE SURE THERE IS AMPLE ROOM FOR
THE BOOM TO CLEAR SURROUNDING WALLS, PARTITIONS AND EQUIP-
MENT.
Raising and Lowering the Boom
NOTE: The lift function is not operable above 15 degrees above
horizontal if the axles are not fully extended.
To raise or lower the Boom, use Boom Lift control to select
Up or Down movement.
Telescoping the Boom
NOTE: The telescope function is not operable beyond the trans-
port position if the axles are not fully extended.
To extend or retract the main boom, use the Telescope Control
Switch to select In or Out movement.
Swinging the Jib
NOTE: For 1000 lb. (450 kg) mode operation, the jib must be
centered and the Jib Swing function is not operable. If the
jib is out of the centered position when in this mode, the
jib swing function will allow the operator to center the jib
again.
To swing the jib, use the Jib Swing control to select Right or
Left direction.
4.10 FUNCTION SPEED CONTROL
This control affects the speed of telescope, main lift and jib
lift. Turning the knob all the way counterclockwise until it
clicks puts drive, main lift and swing into creep mode.