JLG 1100SB Operator Manual - Manual (Page 57)

SECTION 4 - MACHINE OPERATION
3121264 – JLG Lift – 4-7
3. Turn SELECT switch to PLATFORM.
4. From Platform, pull POWER/EMERGENCY STOP switch
out, then push the ENGINE START switch until engine
starts.
NOTE: Footswitch must be in released (up) position before
starter will operate. If starter operates with footswitch in
the depressed position, DO NOT OPERATE MACHINE.
Shutdown Procedure
IF AN ENGINE MALFUNCTION CAUSES AN UNSCHEDULED SHUT-
DOWN, DETERMINE THE CAUSE AND CORRECT IT BEFORE RESTART-
ING THE ENGINE.
1. Remove all load and allow engine to operate at low
speed for 3-5 minutes; this allows further reduction of
internal engine temperature.
2. Push POWER/EMERGENCY STOP switch in.
3. Turn MASTER switch to Off.
Refer to Engine Manufacturer’s manual for detailed informa-
tion.
4.5 TRAVELING (DRIVING)
NOTE: When the boom is raised approximately 15 degrees
above horizontal, all drive functions will be disabled.
DO NOT DRIVE WITH BOOM ABOVE HORIZONTAL EXCEPT ON A
SMOOTH, FIRM AND LEVEL (UP TO THE RATED 3 DEGREES) SURFACE.
TO AVOID LOSS OF TRAVEL CONTROL OR “TIP OVER”, DO NOT DRIVE
MACHINE ON GRADES EXCEEDING THOSE SPECIFIED IN THE OPERAT-
ING SPECIFICATIONS SECTION OF THIS MANUAL.
DO NOT DRIVE ON SIDESLOPES WHICH EXCEED 5 DEGREES.
USE EXTREME CAUTION WHEN DRIVING IN REVERSE AND AT ALL
TIMES WHEN THE PLATFORM IS ELEVATED.