JLG 1100SB Operator Manual - Manual (Page 45)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121264 – JLG Lift – 3-13
Platform Control Indicator Panel
(See Figure 3-4., Platform Control Indicator Panel)
NOTE: The platform control indicator panel uses different shaped
symbols to alert the operator to different types of opera-
tional situations that could arise. The meaning of those
symbols are explained below.
1. Level System Fault Indicator
Indicates a fault in the electronic leveling system. The
fault indicator will flash and an alarm sound. All func-
tions will default to creep if the boom is extended past
transport mode (12 inches [30.5 cm]) or elevated more
than 15° above horizontal.
IF THE LEVEL SYSTEM FAULT INDICATOR IS ILLUMINATED, SHUT
DOWN THE MACHINE, RECYCLE THE EMERGENCY STOP, AND RESTART
THE MACHINE. IF THE FAULT PERSISTS, RETURN THE PLATFORM TO
THE STOWED POSITION, USING MANUAL LEVELING AS REQUIRED,
AND HAVE LEVELING SYSTEM REPAIRED.
2. AC Generator
Indicates the generator is in operation.
3. Platform Overload Indicator (If Equipped)
Indicates the platform has been overloaded.
4. Platform Capacity Indicator
Indicates the maximum platform capacity selected for
the platform.
One of the capacity lights should be on at all times. Both
lights will flash and an alarm will sound if the platform is
out of the operating envelope for the selected capacity.
Indicates a potentially hazardous situation, which if
not corrected, could result in serious injury or
death. This indicator will be red.
Indicates an abnormal operating condition, which if
not corrected, may result in machine interruption or
damage. This indicator will be yellow.
Indicates important information regarding the oper-
ating condition, i.e. procedures essential for safe
operation. This indicator will be green with the
exception of the capacity indicator which will be
green or yellow depending upon platform position.