JLG 1100SB Operator Manual - Manual (Page 96)

SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6-20 – JLG Lift – 3121264
3. The tightening of the nuts should be done in stages. Fol-
lowing the recommended sequence, tighten nuts per
wheel torque chart.
4. Wheel nuts should be torqued before first road use and
after each wheel removal. Check and torque every 3
months or 150 hours of operation.
6.5 SUPPLEMENTAL INFORMATION
The following information is provided in accordance with the
requirements of the European Machinery Directive 2006/42/
EC and is only applicable to CE machines.
For electric powered machines, the equivalent continuous A-
Weighted sound pressure level at the work platform is less
than 70dB(A)
For combustion engine powered machines, guaranteed
Sound Power Level (LWA) per European Directive 2000/14/
EC (Noise Emission in the Environment by Equipment for
Use Outdoors) based on test methods in accordance with
Annex III, Part B, Method 1 and 0 of the directive, is 106 dB.
The vibration total value to which the hand-arm system is
subjected does not exceed 2,5 m/s 2 . The highest root mean
square value of weighted acceleration to which the whole
body is subjected does not exceed 0,5 m/s 2 .
Table 6-15. Wheel Torque Chart
TORQUE SEQUENCE
1st Stage 2nd Stage 3rd Stage
45 ft. lbs.
(60 Nm)
100 ft. lbs.
(140 Nm)
180 ft. lbs.
(252 Nm)