JLG 1100SB Operator Manual - Manual (Page 47)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121264 – JLG Lift – 3-15
5. Tilt Alarm Warning Light and Alarm
Indicates that the chassis is on a slope. An alarm will
also sound when the chassis is on a slope and the
boom is above transport position. If lit when the boom is
raised or extended, retract and lower to below horizontal
then re-position machine so that it is level (within the
rated 3 degrees) before continuous operation. If the
boom is above transport position or telescoped, out and
the machine is on a slope, the tilt alarm warning light will
illuminate and an alarm will sound and CREEP is auto-
matically activated.
IF ILLUMINATED WHEN BOOM IS RAISED OR EXTENDED, RETRACT AND
LOWER TO BELOW HORIZONTAL THEN REPOSITION MACHINE SO THAT
IT IS LEVEL BEFORE EXTENDING BOOM OR RAISING BOOM MORE
THAN 15 DEGREES ABOVE HORIZONTAL.
6. Glow Plug Indicator
Indicates the glow plugs are operating. After turning on
ignition, wait until light goes out before cranking engine.
7. Footswitch/Enable Indicator
To operate any function, the footswitch must be
depressed and the function selected within seven sec-
onds. The enable indicator shows that the controls are
enabled. If a function is not selected within seven sec-
onds, or if a seven second lapse between ending one
function and beginning the next function, the enable
light will go out and the footswitch must be released and
depressed again to enable the controls.
Releasing the footswitch removes power from all con-
trols and applies the drive brakes.
TO AVOID SERIOUS INJURY, DO NOT REMOVE, MODIFY OR DISABLE
THE FOOTSWITCH BY BLOCKING OR ANY OTHER MEANS.
FOOTSWITCH MUST BE ADJUSTED IF FUNCTIONS ACTIVATE WHEN
SWITCH ONLY OPERATES WITHIN LAST 1/4" OF TRAVEL, TOP OR BOT-
TOM.