JLG 1100SB Operator Manual - Manual (Page 48)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3-16 – JLG Lift – 3121264
8. Fuel Level Indicator
Indicates the level of fuel in the fuel tank.
9. Creep Speed Indicator
When the Function Speed Control is turned to the creep
position, the indicator acts as a reminder that all func-
tions are set to the slowest speed. The light flashes if the
control system puts the machine into creep speed and
will be on continuously if the operator selects creep
speed.
10. System Distress Indicator
The light indicates that the JLG Control System has
detected an abnormal condition and a Diagnostic Trou-
ble Code has been set in the system memory. Refer to
the Service Manual for instructions concerning the trou-
ble codes and trouble code retrieval.
The system distress indicator light will illuminate for 2-3
seconds when the key is positioned to the on position to
act as a self test.
11. Cable Service Indicator
When illuminated, the light indicates the boom cables
are loose or broken and must be repaired or adjusted
immediately.
12. Drive Orientation Indicator
When the boom is swung beyond the rear drive tires or
further in either direction, the Drive Orientation indicator
will illuminate when the drive function is selected. This is
a signal for the operator to verify that the drive control is
being operated in the proper direction (i.e. controls
reversed situations).
13. Axles Set Indicator
Indicates that the axles are fully extended. The indicator
will flash as the axles are extending or retracting and be
on solid when fully extended. The light will go out when
the axles are fully retracted.