Volume settings, Fxs interface – 2N VoiceBlue MAX v1.1 User Manual

Page 44

Advertising
background image

44

2N TELEKOMUNIKACE a.s., www.2n.cz

®

Tip

Should there occur call errors (one–way audibility, connection
errors, e.g.), check the settings of all active elements on the
VoIP call route. To detect the problems quickly, you can test the
Point–to–Point connection with a software IP phone (SJ phone,
e.g.) in your PC and use tracing by means of a network analyser
(WireShark –

e.g.) at the same time.

www.wireshark.org

Refer to

for easy tracing through

Subs. 4.2

2N VoiceBlue

®

.

MAX

Tones generated to VoIP

Ring tone to VoIP – generate a ringing tone of your own, or transmit a real
ringing tone from the GSM/UMTS networks.

FXS interface

Profiles

Line impedance profile – select right impedance of analogue line (according to
region where is the gateway installed)

Ring profile – select right type of ringing profile (pattern, voltage, frequency)
- (according to region where is the gateway installed)

Tone profile – select right type of ringing tone (according to region where is the
gateway installed)

Call ID profile – select right type of Call ID profile (FSK mode) - (according to
region where is the gateway installed)

Functions

Day of deleting statistics (every month) – the day of automatic deletion of call
statistics on the VoIP interface. None = no deletion
Tariff pulse type (metering) – possibility to set-up metering pulses sending
(Disabled/12kHz/16kHz)
FXS line selection for incomming calls – selection of destination FXS line(s) in
case of incomming calls from VoIP or wireless networks
DTMF detector during call enabled – enables/disables DTMF detection during
connected call

Caution

Internal CLIPs for FXS ports are: FXS0–100; FXS1–101;
FXS2–102; FXS3–103

Volume settings

Analog to digital gain [dB] – Voice processing settings

Digital to analog gain [dB] – Voice processing settings

Advertising