AirLive G.DUO - Manual (Page 102)

8. WDS + AP Mode
95 AirLive G.DUO User’s Manual
„ Beacon Interval: The device broadcasts beacon frames regularly to announce its
existence. The beacon Interval specifies how often beacon frames are transmitted in
time unit of milliseconds. The default value is 100, and a valid value should be between
1 and 65,535.
„ AckTimeOut: When a packet is sent out from one wireless station to the other, it will
waits for an Acknowledgement frame from the remote station. The station will only
wait for a certain amount of time, this time is called the ACK timeout. In most
conditions, please put ACKtimeout value at zero(default value). The AP will calculate
the ACKtimeout automatically when the value is zero. However, you can also enter
the ACKtimeout manually.
„ Preamble Type: A preamble is a signal used in wireless environment to synchronize
the transmitting timing including Synchronization and Start frame delimiter. In a "noisy"
network environment, the Preamble Type should be set to Long Preamble. The Short
Preamble is intended for applications where minimum overhead and maximum
performance is desired. If in a "noisy" network environment, the performance will be
decreased.
„ IAPP: IAPP (Inter Access Point Protocol) is designed for the enforcement of unique
association throughout a ESS (Extended Service Set) and a secure exchange of
station’s security context between current access point (AP) and new AP during
handoff period.
„ BG Protection: The 802.11g standard includes a protection mechanism to ensure mixed 802.11b
and 802.11g operation. If there is no such kind of mechanism exists, the two kinds of standards may
mutually interfere and decrease network’s performance.
.
„ Hide SSID: Enable Hide SSID will make the AP network’s SSID invisible. A device
can link with the AP only if correct SSID name is entered.
„ Isolation: Enable Isolation will prevent wireless clients to see each other on the
network.
„ TX Power Level: You can set your TX Output power level here. Please note the
maximum allowable TX output power in EU is 20dBm. Please do not exceed your
country’s legal limit.
8.3.4 Access Control
Operation Mode -> Setup -> Access Control
The G.DUO allows you to define a list of MAC addresses that are allowed or denied to