AirLive G.DUO - Manual (Page 118)

12. Frequent Asked Questions
111 AirLive G.DUO User’s Manual
====================================================================
Question : When I wan to use “Site Survey” tool to connect with a AP that has no
encryption, why does the G.DUO report “encryption type mismatch!” and ask
me to configure the wireless security settings?
Answer: When you press “Connect” from site survey, the G.DUO will first check if the
current wireless encryption setting is correct. If not, it will ask you to modify
the setting. Therefore, if your current wireless settings has encryption and
the new AP you want to associate does not use encryption, then the G.DUO
will report the mismatch. In this case, simple select “Disable” in the
encryption field and press “Apply Change”.
====================================================================
Question : When I change my wireless operation mode, why can’t I find my AP anymore?
Answer: This situation can have 2 possibilities..
1. By Default, the DHCP server is turned on in WISP+AP and Gateway+AP
mode. In other modes, the DHCP server is turned off. If you get your
IP address automatically, then when you change to Dual AP, Client+AP,
or WDS+AP modes. Your PC will not be able to get IP address from
DHCP server anymore, therefore, you should set the IP address
manually.
2. When you change the mode to WISP+AP or Gateway+AP mode, the
GDUO’s IP address might change to 192.168.1.254. Therefore; if you
can’t find the device’s IP in these modes, please set your PC’s IP
address to automatically get from DHCP server, then you should find the
G.DUO at 192.168.1.254.
====================================================================
Question : Why can’t I get Telnet or SSH access?
Answer: The Telnet or SSH interface are turned off by default. Please go to “System
Configuration-> System Management” menu to enable them.
====================================================================