AirLive POE-5010HD - Manual (Page 27)

5. Administrating the Device
AirLive POE-5010HD User’s Manual 24
Factory Reset: Click Reset to restore all factory default settings for the camera.
Reboot: Click Reboot to restart the camera just like turning the device off and on. The
camera configuration will be retained after rebooting.
Configuration: You can save your camera configuration as a backup file on your computer.
Whenever you want to resume the original settings, you can restore them by retrieving the
backup file.
- Backup: Click the button to save the current configuration of the camera.
- Restore: Click Browse to locate the backup file on your PC and then click Restore.
You can also click Restore From SD CARD Device if the backup file is saved in the
inserted SD card.
Update Firmware: You can upgrade the firmware for your camera once you obtained a
latest version of firmware.
- Current Firmware Version: This item displays the current firmware version.
- Update: Click Browse to locate the backup file on your PC and then click Update.
Warning!!!
The download firmware procedure can not be interrupted. If the power and/or network
connection are broken during the download procedure, it might possibly cause serious
damage to the device.
Strongly suggest that DO NOT upgrade firmware via Wireless LAN due to high error rate
possibly and don't allow any other clients to access this unit during updating procedure.
Be aware that you should not turn off the power during updating the firmware and wait for
finish message.
Furthermore, the firmware upgrade procedure always is risk and do not try to upgrade new
firmware if it’s not necessary.
5.2 Network: Configure Network Settings
This section provides the menu for connecting the device through Ethernet cable.
The Network menu contains the networking related settings for the camera, such as the IP
Setting, DDNS Setting, IP Filter, etc.
When completed, click Apply to save the settings