AirLive POE-5010HD - Manual (Page 35)

5. Administrating the Device
AirLive POE-5010HD User’s Manual 32
NOTE When High Resolution is disabled, you can only set the Video Resolution as
1280x720 (720P), 720x480 (D1), 640x480 (VGA), 320x240 (QVGA), or
176x144 (QCIF).
- Rate Control: Set the proper image quality by selecting Video Quality or Bitrate,
and then select the desired settings from the pull-down menu:
Video Quality: Select Very Low, Low, Normal, High, or Very High from the
pull-down menu.
Bitrate: Set a proper value (in kbps) depending on your network status.
- Mobile View (Not supported by MPEG4): The camera supports 3GPP specification.
Select the Disable option to disable this feature. Otherwise, select 3GPP Without
Audio or 3GPP With Audio to transfer the video clips without or with audio.
If you use a mobile phone that supports 3GPP, you can also view the real-time
streaming image captured by the camera on your phone (with the default player on
the phone) by entering the RTSP link:
rtsp://(IP address of the camera)/3gp
NOTE Your mobile phone and the service provider must support 3GPP function.
Please contact your service provider when you are failed to use this service.
5.3.2 Audio
Enable Microphone: Select the option to enable the camera’s audio in function, so that
you can receive the on-site sound and voice from the camera.
Enable Speaker: Select the option to enable the camera’s audio out function, so that the
connected speaker can play the sound and voice through the camera.